Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

supply for fpga board

Status
Not open for further replies.
B

Bosechandran

Junior Member level 1
Joined
Dec 9, 2016
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
126
dear sir
shall i use desktop pc usb output power for fpga 3s250e power supply. usb output is 5v and spartan kit power requirement is 5v. data transfer is different. im asking about power to the board.


thank you
 

Hi,

It depends on the requirements.
If I remember right...USB voltage is specified to be 4.5V ... 5.5V. Max 0.5A.
I'vd seen: less than 4.5V (loaded) .... 5.2V


PC supply: maybe it needs a "minimum load" to work properly.
Don't know about soecification.

Also read specification of FPGA board.

Klaus
 

KlausST said:
Hi,

It depends on the requirements.
If I remember right...USB voltage is specified to be 4.5V ... 5.5V. Max 0.5A.
I'vd seen: less than 4.5V (loaded) .... 5.2V


PC supply: maybe it needs a "minimum load" to work properly.
Don't know about soecification.

Also read specification of FPGA board.

Klaus
Click to expand...


thank you sir
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top