Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Development of Trigger Signal Distributer

Status
Not open for further replies.
M

Mukun

Newbie level 1
Joined
Jun 14, 2016
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
I have 8V trigger signal and i needs to distribute the same trigger signal to four different devices,need suggestion on how to achieve this as i am not getting any fanout buffer or line drivers which take 8V input. Should i consider step down 8V to 3.3 V , fanout one to four and then again step up 3.3 to 8V need suggestion's and advice's to achieve this.

Thanks
Mukund
 

The original CMOS CD4000 logic can operate up to 15v, and offers both inverting and non-inverting buffers.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top