Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

engineered continuous wave signal source at the ISM frequency of 13.56Mhz.

Status
Not open for further replies.
M

musclemania05

Junior Member level 2
Joined
Feb 9, 2016
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
197
hello all I'm needing help with a project I was assigned and here it is:

Design a engineered continuous wave signal source at the ISM frequency of 13.56Mhz. This will be for a closed (non-signal radiating) application. Power level of at least 10 watts into a 50 ohm non reactive load , an appropriate RF WATTMETER and dummy load for testing the power level should be used.

I not sure how to approach this project, meaning like designing it, components, what type of power source to use, etc.
Would greatly appreciate comments
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top