Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

confused about sample rates

Status
Not open for further replies.
E

engineer1000

Advanced Member level 4
Joined
Aug 16, 2012
Messages
106
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,060
Hi,
I am now really confused. With reference to the reply below



" on the other hand, you were willing to work with a slighlty reduced bandwidth and sample rate of 125S/s, then you could use a PicoScope 5442A."

The 5442A is spec'ed at up to 1GS/s real time sampling, even using 4 channels would give me 2150KS/s . So I really don't understand where the 125S/s comes from.
THANKS
 

Hi,

Usually with digital scopes..when you change the timing (ms/div) you change the sample rate.

So i assume the 5442 is able to sample with max 1Gs/s, but it may be set up for a lower sample rate.

Klaus
 

Quoting a single sentence picked up somewhere without a link or explaining the context seems to me like a useless post

If the question is somehow related to your thread https://www.edaboard.com/threads/349076/ you should consider that a related questions should be asked in one thread.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top