Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

advanced design system 2014 - how move ports to inner edge of pads

Status
Not open for further replies.

Sarvenaz

Junior Member level 1
Joined
Dec 2, 2015
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
110
:hi
i use a cap(art work),which has tow pads,in schematic for making layout with its own port(->).the end of the ports are located on outer edge of pads so the cap become wider than the microstrip line that is near the cap.how can i move the the ports to inner edge of the pads or delete them and put new ports to inner edge of the pads?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top