Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Time Multiplexing Two Channels Into Single Channel Using PAM

Status
Not open for further replies.
I

iraqi maniac

Newbie level 1
Joined
Nov 13, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Two low pass signals, each band limited 4KHz, are to be time
multiplexed into a single channel using PAM. Each signal is impulse
sampled at a rate 10KHz. The time multiplexed signal waveform is
filtered by an ideal LPF before transmission.
(a) What is minimum clock frequency of the system?
(b) What is the minimum cut off frequency of the LPF?
(c) In the receiver side, determine the minimum and maximum
acceptable bandwidth of the LPF used in retrieving the analog
signal?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top