Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
I'm trying to control a H-bridge with one IR2112 driver, the circuit works, but burning driver with few uses. I am using P channel Mosfets on and channel Mosfets N down and not have the bootstrap circuit will be necessary?
i will appreciate any suggestion or critics, thanks in advance
I would rather fear shootthrough and output transistor burning... In this case, the driver might be damaged as a consequential error.
What's Vdc level?
Vcc must have bypass capacitors, D1 should be replaced by a short. Exceeding Vcc rating would be my first guess if the output transistors are still healthy.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.