Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[AVR] Internal clock settings for at89c5131 ?

Status
Not open for further replies.
F

falcon026

Newbie level 6
Joined
Dec 22, 2014
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
99
A very basic question:

what are the registers settings required to enable internal clock of AT89C5131?

is it just defining FOSC with the clock speed ?
kindly rep asap ...
 

According to datasheet, there's no internal clock feature provided with AT89C5131.
 

but on 1st page it is mentioned that : 0-32MHz on chip oscillator is there ...
 

Why don't you read the data sheet completely? It clarifies that a crystal or ceramic resonator has to be connected to XTAL1/XTAL2 pins to use the on-chip oscillator.

I agree that the different terminology used by µC vendors can be confusing, e.g. "internal oscillator" of Microchip PIC (a RC oscillator working on its own) versus "on-chip oscillator". In case of doubt you to read the datasheets thoroughly.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top