Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

help for flyback converter

Status
Not open for further replies.
A

atlantis83

Junior Member level 1
Joined
Feb 22, 2005
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,416
hello
I got a project in "Power electronic" lesson.It is about a flyback converter which converts 6V to +12V,-12V and 5V.So it is a 3 terminal circuit and I will use inductors and transformers also.If you have information or know any sources about this project,please confirm me.
thanks.
 

If you are looking for design resources, go to Texas Instruments' website www.ti.com and search for Flyback. The Unitrode (purchased by TI in 1997) seminars are available on-line.

I can also help with the design, just post a few more requirements: currents, line/ load regulation, input voltage range, temperature range.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top