Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Running ASITIC on Windows

Status
Not open for further replies.

aryajur

Advanced Member level 3
Joined
Oct 23, 2004
Messages
793
Helped
124
Reputation
248
Reaction score
37
Trophy points
1,308
Location
San Jose, USA
Activity points
7,788
asitic_cygwin.exe

Hello,
I want to use ASITIC on a windows PC. I downloaded the setup file. Then I downloaded and installed Cygwin. Now when I run the asitic_cygwin.exe file it gives me the message:

This application has failed to start because cygX11-6.dll was not found. Re-installing the application may fix this problem.

What should I do to correct this? What all steps are re quired to use ASITIC??

Added after 47 minutes:

I could run ASITIC Finally, after I installed the X11 Libraries in Cygwin. But now the problem is ASITIC after asking the Technology file name gives a Fatal error and says that it could not open display.
I checked the XFREE86 libraries, they are no longer present in Cygwin. Is there any way over this problem??
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top