Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[General] embeded system programming

Status
Not open for further replies.
T

tapu

Full Member level 4
Joined
Sep 15, 2014
Messages
234
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
india
Activity points
3,041
Hi,I am using keil uvision.I programmed AT89c51 chip by USB programmer up to 2090 bytes code.then controller takes some time to start running on actual board.And if I remove some part of programme to 2080 bytes (without any error) then runs normally.as my actual seize of programme is 2335bytes which runs on proteus & does not run on board.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top