Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If I use a reference PCB, with some parts of circuit pre-routed. And start to produce the schematic from scratching (in Orcad), is it possible to get all ref designators from my pcb file (Allegro brd, in this case) ?
If not, how could I reuse the critical parts of this layout in my design ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
