Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

in case of std cell layout what are the differences in 65 & 28nm for drawing poly?

Status
Not open for further replies.

ms_90

Member level 2
Joined
Apr 9, 2014
Messages
46
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
275
in case of std cell layout what are the differences in 65 & 28nm for drawing poly?

actually i know the common differences like more DRC, density errors, WPE, LOD effects etc.

But with respect to poly what are the difference? allowed routing direction, poly break, poly jog etc

and also why do we go for poly pitch in 28nm?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top