Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

fault and fault detection in vlsi circuit

Status
Not open for further replies.

vead

Full Member level 5
Joined
Nov 27, 2011
Messages
285
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
india
Activity points
3,815
I am looking information. can someone explain what is fault and fault detection in vlsi circuit
 

In vlsi fault refers to a signal b stuck at logic 0 or logic 1.
There exist different technique to determine the fault that exist in combinational or sequential circuits.
In complex circuits we don't know which lines(nets) are faulty ,so there exist different fault detection method to find these faulty nets(Deductive ,parallel, concurrent, ATPG..etc).
 

I understood testing is used to determine fault in chip
fault may be occur during fabrication , during connection , during packaging

Q1 If fault is present in component , which testing method we will use to detect fault ?
Q2If fault is present in interconnection , which testing method we will use to detect fault ?
Q3 If fault is know, can we recover fault in chip ?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top