Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How many isolated dc sorce for multilevel inverter

Status
Not open for further replies.
kappa_am

kappa_am

Full Member level 6
Joined
Jul 16, 2012
Messages
331
Helped
19
Reputation
38
Reaction score
19
Trophy points
1,298
Location
Vancouver
Activity points
3,859
just a basic question.
I am going to implement a hybrid multilevel inverter, how can I calculate how many isolated dc source that are needed to drive IGBTS?
I know it depends on structure of inverter but I'm not sure how to assess the number of isolated dc sources.
 

So long as multiple IGBTs share an emitter node, they can use the same gate driver supply. So basically for each node with IGBT emitters, you need a gate drive supply.
 

Thanks for your reply:)
so a simple 3-phase inverter needs 4 isolated gate drive DC sources? A question is risen: so how a compact driver for a 3-phase inverter works just by a single dc source?
another question is that: is there any way to reduce these sources? I assessed, and it seems I need 22 isolated DC sources!!!
 

so how a compact driver for a 3-phase inverter works just by a single dc source?
Click to expand...
It probably uses a bootstrap circuit. A capacitor is charged through a diode while the low-side switch is closed.

Usual high power IGBT drivers are combining the drive and error signal isolation with an isolated DC/DC converter.
 

Correct, on most high power (like >10hp) drives I've seen, actual isolated DC supplies are normally used for every IGBT (except maybe parallel IGBTs may share a gate drive supply), and the bridge is completely isolated from the control electronics.
 
so it means I have to use 22 isolated DC source for my circuit! wow. could you possibly share a simple dc source schematic suitable for 300V 5A IGBTs?

thank you very much
 

The supplies don't need to be very well regulated, so you can use a multi-output flyback topology. I've seen up to 6 outputs per flyback generated like this, but you need a good transformer with appropriate isolation ratings.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top