Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

pure sine wave inverter problem

Status
Not open for further replies.

pakkiboy

Member level 1
Joined
Aug 4, 2013
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Location
Jeddah, Saudi Arabia, Saudi Arabia
Activity points
222
I have made circuits for pure sine wave inverter. first i have used SG3525 to covert 12v DC to 300 Dc , then i have make full bridge using Ir2101 and Mosfet 3205 , mine main issue when i give output of first crkt ( 300 v DC ) to drain of mosfets in bridge circuit , 300 dc voltage drops to 60 v dc and about 5 A current flow :( any help??
 

first of all you check the primary converter. disconect the 300vdc to the drain of mosfet. now conect a 100watt 230vac rated bulb on 300vdc
now check the 300vdc if it drops then their is a problem in primary converter

post your schematic & photo here
 

yes for temporary testing you can conect a 100watt bulb

- - - Updated - - -

or if you have a load resistor of 100watt that also be ok
 

I have used this circuit ... as feedback is given in it , then why voltage drop to extreme level ?? any help ?

Regards

- - - Updated - - -

this is crkt diagram of frst stage i used
http://obrazki.elektroda.pl/4566970400_1379271846.png
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top