Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Connect input drive signal to ULN2803 input pin. Connect lamp between the corresponding output pin and +V. Connect pin 10 (COM) to +V. In Proteus, the common emitter pin of ULN2803 is hidden and is connected to ground.
By the way, for driving a single lamp, you can just use a transistor. You don't need to use ULN2803.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
