Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

changing 12V DC to about 150V DC

Status
Not open for further replies.

kokosz

Member level 1
Joined
Jul 17, 2012
Messages
41
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,546
Hello, I want to make voltage converter from accumulator 12V DC to about 150V DC. I' ve seen a few schematics but I cant understand them.
How i can make about 150V DC from 12V DC?
 

You can use a DC-DC boost converter (1-transistor boost converter).

You can also use a push-pull converter.

I recommend using the push-pull converter, as, when the switches are off, output is zero, whereas in the boost converter when the switch is off, VOUT = VIN. And the output is isolated from the input as well.

For push-pull converter, take a look here:

**broken link removed**

Hope this helps.
Tahmid.
 

The above shown diagram (in post #4) is like a flyback converter.

An RCD snubber should be used across the transformer primary. Another snubber could be used across the MOSFET (to reduce the rate-of-rise). At the secondary, a single diode followed by an LC filter should be used to convert to DC (the inductor may be omitted) - not a bridge rectifier.

Hope this helps.
Tahmid.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top