Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

poly orientation in 28nm in TSMC

Status
Not open for further replies.
S

schowdary

Newbie level 5
Joined
Jul 14, 2010
Messages
10
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
hyderabad
Activity points
1,334
Anisotropic process steps cause assymetries in process. The mismatches caused by this effect can be avoided by maintianing same orientation such that the current flow will be strictly in one direction.

And poly orientation issue might come under DFM issue too.. the stress effect will be different for different orientations. One might effect the other.

even I'm a newbee to 28nm though. just sharing my thoughts.
 

I agree. We can just flip it , but can not 90 degree oritating
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top