Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

components in microwave band

Status
Not open for further replies.
actra

actra

Member level 5
Joined
Nov 9, 2004
Messages
90
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
cairo [EGYPT]
Activity points
851
hello there,

my question is...
in microwave band typically 1.3 ghz ...imean in the design can i use normal resistors and capacitors and inductors in the design at this high frequency ?

because ive found a wireless transimitter in this band and i found resistorsand capacitros in the schematic but not sure what to order ??? any suggestions?

thank you vmuch
 

At this frequency surface mount ones will work. Double check the data sheets for parameters such as self resonant frequency.

If this is a through hole design the construction and part selection is very tricky and beginners will invariably not be able to make the project work.
 

thank you flatulent ...
and yes its a surface mount ...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top