drtvskuthsav
Member level 2
Hi,
I was trying to design a buck converter as shown in the attached file. When I simulate the converter design in proteus with PWM generated by ATmega32 it is giving a error
"Timestep Too Small"
Can you please try to help me with this.
Attached: Schematic of the converter and the screen shot of the error message.
Thank you.
- - - Updated - - -
The switching frequency used is 1.96kHz
I was trying to design a buck converter as shown in the attached file. When I simulate the converter design in proteus with PWM generated by ATmega32 it is giving a error
"Timestep Too Small"
Can you please try to help me with this.
Attached: Schematic of the converter and the screen shot of the error message.
Thank you.
- - - Updated - - -
The switching frequency used is 1.96kHz