Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Port refinement, process hf3d error: Too few conductors were found on port WavePort1.

Status
Not open for further replies.
probably this happens with imported model, where in the port sees the same conductor on both sides.
In other words there may be two conductors on the same layer across which port is connected(eg, ground and signal)
If this is the case the conductor has to be separated.
 

I am trying to design the split ring resonator proposed in Electromagnetic parameter retrieval from inhomogeneous metamaterials i.e FIG-2 of the paper in HFSS-11.After simulation though magnitude response of S11 and S21 parameter is getting a exact match but phase response of S11 and S21 is not matching.Can you kindly suggest me where i am going wrong?I had attached both hfss file and the paper which i am following.In EDA board there is a same kind of problem discussed in the following link but it is not conclusive https://www.edaboard.com/threads/102952/
 

Attachments

  • Smith.rar
    9.1 KB · Views: 91
  • Electromagnetic parameter retrieval from inhomogeneous metamaterials.pdf
    871.5 KB · Views: 67
  • Like
Reactions: FvM

    FvM

    FvM

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top