Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Isis proteus 7.7 how to display the component in ISIS

Status
Not open for further replies.
A

amir ariff

Newbie level 3
Joined
Dec 29, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,298
when i click the component that i want to use, the component didn't display in the design.
HOW TO DISPLAY THE COMPONENT? i hope i can solve this problem earlier.
 

You open the device panel and you click to add the device to the project.
Then click on the device shown in the left panel device list and click again to place it in the schematic.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top