Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to get the Gm of an OTA ?

Status
Not open for further replies.
N

neo

Member level 2
Joined
Aug 19, 2004
Messages
51
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Beijing
Activity points
450
how to get Gm.

hi, brothers, i am studying an active filter but i donnot know how to get the Gm of the OTA, can Cadence analog artist do this job? how? using the calculator or else?
thanks a lot!
 

Re: how to get Gm.

Any AC simulator can calculate the Gm: just follow the definition and plot the output signal current vs. the input signal voltage.
Mazz
 

Re: how to get Gm.

For a transistor, just do DC analyze and use calculator-> OP -> selecting component -> gm, print it
 

Re: how to get Gm.

By adding a expression OP("/M1", "gm") as output, gm vs sweep source curve can be plotted after DC sweep. M1 is the instance name in the top cellview.
 

how to get Gm.

For a transistor you can get gm from Results-Print-DC Operating Points after DC simulation.
 

Re: how to get Gm.

If you mean the Gm of a multiple-transistor OTA circuit, you have to test it. You want to put a dc/ac source at input, a dummy voltage source at output, and do dc, TRAN AND ac analysis. At small signals, the result from dc and TRAN should agree with that from ac analysis. Otherwise you got a problem.
 

Re: how to get Gm.

Hughes said:
By adding a expression OP("/M1", "gm") as output, gm vs sweep source curve can be plotted after DC sweep. M1 is the instance name in the top cellview.
Click to expand...

This does not work, it only prints the value.
 

Re: how to get Gm.

markl said:
Hughes said:
By adding a expression OP("/M1", "gm") as output, gm vs sweep source curve can be plotted after DC sweep. M1 is the instance name in the top cellview.
Click to expand...

This does not work, it only prints the value.
Click to expand...

If the DC sweep is not selected, OP("M1","gm") can only get a scalar value which will be printed in the simulation window. But if DC sweep is selected, OP("M1","gm") will be a wave and can be plotted in the wave window.
 

Re: how to get Gm.

How to plot transistor's gm and other intrinsic parameters, see:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top