Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What is low and high level Modulation

Status
Not open for further replies.

Cisco

Newbie level 6
Joined
Oct 17, 2011
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
San diego
Activity points
1,377
What is the difference between low level modulation and high level modulation?
 

in Analog modulation system, the AF signal is modulated by a High-frequency carrier oscillator signal. This is Low-level modulation. After this modulation, the resultant modulated signal will be applied to the input of a RF power amplifier. Just after this amplification, a second-stage of modulation is performed with another carrier-oscillator. This is High-level modulation. After this the signal will be sent out for transmission.

So, Low-level modulation is done on a signal whose power-level is low and High-level modulation is done on the signal whose power level is high.

Hope this helps.
 
  • Like
Reactions: Cisco

    Cisco

    Points: 2
    Helpful Answer Positive Rating
For AM only
The most important aspect is that is if low level modulation is used all the resultant RF amplification stages must be linear. High level modulation is the variation of the power into a non linear RF power amplifier.
Low level :- low modulation signal power, lots of linear RF amplifiers.
High level :- lots of non-linear Rf amplifiers, lots of modulation amplifiers with a high power output (1/2 carrier power). Not for SSB.
For FM/FSK/Digital only low level modulation as RF amps can be non linear.
Frank
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top