Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Model categories for Cadence 5.0.33

Status
Not open for further replies.
M

m_mosazadeh

Member level 4
Joined
Apr 25, 2004
Messages
69
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,286
Location
iran
Activity points
350
cadence 5.0.33

hello all,

I found a problem with this version of cadence.

which pdk must I use with this version of cadence?

and about spectre cmos model:is this model diferent from hspice model?

if yes please upload cmos .25um spectre model.


thanks
 

Re: cadence 5.0.33

Hi

from the simulation ascpect

You have to choose from one of the following model categories

Either MOSFET LEVELS
OR HSPICE equivalent LEVELS

Then find out simulation parameters for you.


For example:

MOSFET LEVEL 13 == HSPICE LEVEL 49

MOSFET LEVEL 14 == HSPICE LEVEL 54

and so on and so force.


Also Look at:

1. h**p://www.mosis.org/Technical/Testdata/menu-testdata_mep.html
2. h**p://www.mosis.org/Technical/Testdata/tsmc-025-prm_mep.html


* -> t

tnx
 

Re: cadence 5.0.33

Hi

The above mentioned links are for classroom tests.

These two links are more sophisticated:

1. h**p://www.mosis.org/Technical/Testdata/menu-testdata.html
2. h**p://www.mosis.org/Technical/Testdata/tsmc-025-prm.html


* -> t

tnx
 

Re: cadence 5.0.33

To convert the Spice format model file into spectre format,
add "simulator lang = spice" on the top part as the first uncommented line and "simulator lang = spectre" at the bottom.
 

Re: cadence 5.0.33

santhoshv78 said:
To convert the Spice format model file into spectre format,
add "simulator lang = spice" on the top part as the first uncommented line and "simulator lang = spectre" at the bottom.
Click to expand...

You sure this is OK? Did you compare the equations and model parameters? Please let us know.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top