ffsher100
Junior Member level 3
I have test self biasing circuit from Razavi textbook.
test condition:
(1) .op
(2) vdd vdd 0 PWL 0n 0v 1u 0v 1.1u 3.3v
(3) .tran 1n 5u
when running on hspice, the warning message:
//=============== message begin =======================//
**warning** dc voltage reset to initial transient source value
in source 0:vdd new dc= 0.0000D+00
//=============== message end =======================//
Is any way to avoid the warning?
Or, the message just fine and doesn't effect result?
test condition:
(1) .op
(2) vdd vdd 0 PWL 0n 0v 1u 0v 1.1u 3.3v
(3) .tran 1n 5u
when running on hspice, the warning message:
//=============== message begin =======================//
**warning** dc voltage reset to initial transient source value
in source 0:vdd new dc= 0.0000D+00
//=============== message end =======================//
Is any way to avoid the warning?
Or, the message just fine and doesn't effect result?