Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to change page size when creating a footprint in Allegro PCB editor

Status
Not open for further replies.
H

hopking

Newbie level 3
Joined
Jun 16, 2011
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,301
Hi, I got a problem when creating a footprint symbol for a 64pin connector using Allegro PCB editor 16.3.
The default page size is about 800*800mil, but my connector is 36mm*6mm, which far exceeds the page size.
I tried but still can't figure out how to change the page size. Anyone can tell me how to do this? Thank you!
 

hi
check this , go to setup--> design parameteres-->design tab and increase page width and size here
SA
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top