Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Expedition2007.9 constarints editor

Status
Not open for further replies.
L

Logiks

Junior Member level 3
Joined
Sep 17, 2009
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
India
Activity points
1,455
Hi All,

I am using expedition 2007.9 cad tool with using CES.

In both layout and schematic (Ex:+3V3) net is available ,but not loaded one particular net in constraint editor.Except one net all nets loaded in CES.

I never came acroos this issue before.

Could any one please reply me to solve this issue ?

Thanks in advance .
Regards,
Logiks
 

Hi All,

I got solution for this .Please follow as mentiined below
In CES go to -->setup-->settings-->Poweand grounds tab. Now you can modify the netclass and enable the visible mode.
Once done this net visible under nets tab.

thanks,
Logiks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top