Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Virtuoso Schematic Editor - parameter display

Status
Not open for further replies.
D

dkace

Full Member level 6
Joined
Jun 13, 2002
Messages
395
Helped
32
Reputation
64
Reaction score
7
Trophy points
1,298
Location
Greece
Activity points
3,562
Does anyone know how I can select to display the cell's parameters WITHOUT running a simulation first in virtuoso schematic?

I place the pfets and nfets and I have to click "properties" to check there parameters whereas if I run a simulation, I can do an "annotate" and everything is displayed.

Does anyone knows a more direct approach?

Thanks,

D.
 

As mentioned above, I want to be able to do it WITHOUT running ADE. Is there any DIRECT way to do it , other than running any simulation before annotation?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top