jbisht
Member level 1
Grilled with this error :
CD0082: Failed MPLAB ICD 2 operation
...Failed to reset target
I am using pic16f882 in debug mode.
LCD error RED LED show error.
what to do??
---------- Post added at 06:00 AM ---------- Previous post was at 05:47 AM ----------
The exact problem is MCLR pin of micro is intially high, on connecting to ICD2 it goes LOW but on building project in debug mode this pin goes high and remans high.
what the solution for this.....???
CD0082: Failed MPLAB ICD 2 operation
...Failed to reset target
I am using pic16f882 in debug mode.
LCD error RED LED show error.
what to do??
---------- Post added at 06:00 AM ---------- Previous post was at 05:47 AM ----------
The exact problem is MCLR pin of micro is intially high, on connecting to ICD2 it goes LOW but on building project in debug mode this pin goes high and remans high.
what the solution for this.....???