Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to convert from dmips to mips ?

Status
Not open for further replies.

5282604

Full Member level 4
Joined
Dec 19, 2009
Messages
194
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
egypt
Activity points
2,404
how can i convert from dmips to mips

for example
1.56 dmips/mhz
 


dmips

thank's
I can not find a final solution ?
 

dmips

I can not find a final solution ?

why do you post if you aren't going to read the answers hakeen provided to you?
 

dmips

Mips is architecture dependent, DMIPs supposed to be architecture independent.
Both are utterly useless when you want to determine whether a special device will provide enough performance to execute a given task. to be fair though, MIPS are even a little bit more useless than DMIPs.
Use a small program that represents an important part of your task and execute that one on an evaluation board. That's the way to go.
For ARM or 51 and I am sure for many other devices too, there are simulators that can provide a good approximation.

hth, Bob
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top