Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Plated Copper Thickness

Status
Not open for further replies.
T

tennythomas

Member level 2
Joined
Jul 23, 2010
Messages
48
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,583
Is it possible for the copper foil (0.7mil) on the top layer to be plated to 1mil (finished copper on the top layer = 1.7mils) and the copper foil (0.7mil) on the bottome layer to be plated to 1.5mil (finished cu on the bottom = 2.2mils) differently?

Thanks in advance.
 

I would think yes this is possible. It would require masking of external layers during plating process. This does add to cost of fabrication however.

Another issue that might arise from doing this is warpage.

Eda
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top