tmogpjh
Newbie level 5
after installing RFDE2008, I simulated a simple circuit. But there's an error message. The error message was below...
----------The error message----------------------------------------------------
Error detected by hpeesofsim during netlist flattening.
Undefined parameter 'off' used by 'Q0.region'.
........
........
.......
hpeesofsim terminated due to an error.
ds2psf_exe--ERROR: Cannot access file /root/simulation/example/ADSsim/schematic/netlist/data.ds.
\nds2psf was unsuccessful. PSF files are not available for this simulation.
----------The end of message----------------------------------------------------
plz tell me a solution. Thx~
----------The error message----------------------------------------------------
Error detected by hpeesofsim during netlist flattening.
Undefined parameter 'off' used by 'Q0.region'.
........
........
.......
hpeesofsim terminated due to an error.
ds2psf_exe--ERROR: Cannot access file /root/simulation/example/ADSsim/schematic/netlist/data.ds.
\nds2psf was unsuccessful. PSF files are not available for this simulation.
----------The end of message----------------------------------------------------
plz tell me a solution. Thx~