Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the dielectric constant for soldermask is lower than that of air. therefore, for outer layer traces, adding a thin dielectric such as soldermask has the effect of *lowering" the impedance.
you need to change the trace width if it fall sin both mask and unmask region to get constant impedance. To view the chage you can use polar software or if you are usig Allegro Expert it can do it for you too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.