Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Guide for design 4 layer pcb in PADS2005

Status
Not open for further replies.
P

pinki patel

Newbie level 6
Joined
Sep 1, 2009
Messages
12
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Location
nashik
Activity points
1,363
four layer pcb

hi friends
plz guide me to design four layer pcb in pads2005.
i hav the previous experiance in 2 layer designing in pads2005
but now i want to design in 4 layer,so i dont hav any idea abt multilayer board
so plz give me guidline?plz...........
 

pads 2005

1.Do the stack up as 4 layer (S,Gnd,Vcc,S)
(Select the Vcc and Gnd as planes)
2.Hide the power and gnd nets.
3.Fanout(take connection from pin and select end via) all the Power and Gnd Pins of all Smd components.
4.Do the routing as 2 layer
5.If different voltages select the vcc layer and split the plane.
6.Generate gerber like 2 layer and extra inner layers
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top