Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pid heater - is tuning to get parameters needed?

Status
Not open for further replies.
S

srajakkannan

Newbie level 1
Joined
May 19, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
pid heater tuning

I have a heater which I would like to ramp at a constant rate until the set point temerature. I would like to ramp the heater at a certain rate say x deg C/min until it reaches the set temperature. the heater is a band heater which is heating up water inside a cup. The band heater is around the cup. Would i need to tune my pid to get those paramters or is it just a proportional system.
Thanks,
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top