Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Does any oneknow how to draw grating figure on CST?

Status
Not open for further replies.
J

joyhappy84

Newbie level 4
Joined
Feb 4, 2009
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,319
Hello all,
I want ot simulate nanostrip figures in CST. but i don't know how to draw this figure. I upload a picture with the structure what i want to draw? the left one is 3D view, the right one is the cross section.
Anyone could give me some suggestions?
Thanks,
Joy
 

Draw your rectangle with the layers you need. now draw bar near it than chamfer
it in two sides rotate it and copy this bar n times. then subtracts this bars from your
rectangle and you get it.

pl
 

Thank you very much. I will try that.. :)
 

just draw a unit cell and define the boundary conditions "periodic" in the certain direction.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top