Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
first you make Schematic file then transfer the net list to Allegro and then you route & change the Ref.Des. & net connection After that you need to back anotate to schematic . that is ok open Capture & open the Schematic then select Back Anotation from Tolls as shown below
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
