Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to draw a single pad in Altium DXP 2004 schematic?

Status
Not open for further replies.
H

helloedaboard

Newbie level 1
Joined
Oct 13, 2008
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,286
How to draw a single pad in Altium DXP 2004 schematic? I mean to put a symbol in the DXP schematic then it transfer to a pad in the pcb automatically when updated.

Thanks
 

You would have to make a symbol with at least one pin in the Schematic Library, and a corresponding single pad as a footprint in the PCB Library. You would then enter the pad footprint in the schematic symbol as the footprint model. Now when you use your symbol in the schematic, DXP will use the PAD as the footprint on the PCB.

In other words, you treat the pad like any other component.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top