Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to re-use the same measurement settings in Orcad Pspice?

Status
Not open for further replies.
kudjung

kudjung

Member level 4
Joined
Jan 17, 2003
Messages
77
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
734
Orcad Pspice help

Hi,

I've just started using Orcad Pspice. I create a custom measurement result in Probe but everytime I re-simulate it, I have to add that measurement formula again(I use add trace and then enter formula). Is there any way we can either enter a custom mesurement in schematic(I only use probe to probe the node) or saving my measurement setting so that everytime I re-simulate the stuff, it display the measurement I want.

Thanks a lot and happy holiday.
KJ
 

If your are using PSpiceAD, you can access "window/Display Control"
then give a "New Name" and save.
when you want to reuse, you can "Restore".

happy holiday!!!
 

Re: Orcad Pspice help

Hi,

If you are using Pspice Schematic Capture (not Orcad Capture), in the menu Analysis, select Probe Setup and check Restore last Probe session.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top