Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ERROR -- Expecting keyword STIMULUS, saw SIGNAL.

Status
Not open for further replies.

spice freak

Newbie level 3
Joined
Sep 22, 2008
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,301
expecting keyword stimulus

Hi,


why am i getting the following erors?

"ERROR -- Expecting keyword STIMULUS, saw SIGNAL."

please help me!
thanks.
 

error -- expecting keyword stimulus, saw 0.

It would be of help if you mentioned what was giving you this error and the code/circuit or whatever it is that is causing it.
 

expecting keyword stimulus, saw 0

Hi,

Thanks for getting back to me.

I actually solved the problem in a stupid way. Apparently I just needed to change the GND name to "0" (zero). before that I was using GND_FIELD SIGNAL ground.

FYI, here is the schematic:

---------------------------------
* source TESTTRANS
L_L1 N00746 N00422 1000H
R_R4 N00233 N00746 1k
C_C4 0 N00422 25uF
V_V1 N00233 0
+SIN 0V 1V 100kHz 0 0 0
---------------------------------

just a simple RLC circuit that I used to test my other problem which is with modelling. I will post it soon (in the same section, please look for "how to model ua741 opamp").

Thanks again.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top