Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Making a usb controller or usb interface with avr and pic

Status
Not open for further replies.
Fragrance

Fragrance

Advanced Member level 4
Joined
Jul 26, 2002
Messages
1,190
Helped
248
Reputation
496
Reaction score
202
Trophy points
1,343
Location
East Of Earth
Activity points
8,933
hi

here is link to make your own usb interface with avr or pic micro


http://www.cesko.host.sk/IgorPlugUSB/IgorPlug-USB%20(AVR)_eng.htm
 

Re: Making a usb controller or usb interface with avr and pi

Where is the USB inteface for PIC :?:
Please read the contens of the link before you post it!
I can only see an USB interface for AVR.
The PIC is too slow to make a software USB interface (maybe the new PIC18 is fast enough if it is overclocked???).

Text from the link:
Firstly I choose PIC16F84-20, with which I have experiences. To ensure synchronizing with USB clock and speed increasing was used microcontroller clock 24MHz = 6MIPS (PIC was slightly overclocked). For one bit from USB processing were 4 instructions (4=6MIPS/1.5Mbit for LowSpeed USB). I reject this solution (after some time) - PIC is too slow (and in addition the no so good instruction set ...) .

Anyway the IgorPlug link have been posted many times before.

There is a 2nd link for AVR USB:
USB-RS232 converter + USB-8/16bit converter + USB-EEPROM scratch pad based on cheap AVR microcontroller
www.cesko.host.sk/IgorPlugUSB_RS232/IgorPlug-USB%20(AVR)%20RS232_eng.htm
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top