Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What do you mean exactly? Do you have a package where pins are connected internally?
This wouldn't normally be handled by editing the footprint, but by connecting the appropriate nets on the schematic. If you want to route signals into and then out of the device that's usually a bad idea.
When you've placed the footprint you could edit the pads and assign the appropriate net to them.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
