Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to block dummy metal fill

Status
Not open for further replies.
L

lijianheng

Full Member level 2
Joined
Sep 29, 2006
Messages
125
Helped
13
Reputation
26
Reaction score
5
Trophy points
1,298
Activity points
1,826
Hi,

When I run DRC, there is density error. But I don't want foundry auto fill dummy metal in some part. Which layer (layer name & type in LSW) should I use to block those part?

Thx
 

You can draw dummy Blockage layer at ther place where you don't want auto filling. for example, To block M1 metal filling at foundary, Draw M1 _dummy blockage layer.
for proper layer info, consult with ur CAD department
 

    L

    lijianheng

    Points: 2
    Helpful Answer Positive Rating
yes,just add dummy metal layer
 

ajaytronic said:
You can draw dummy Blockage layer at ther place where you don't want auto filling. for example, To block M1 metal filling at foundary, Draw M1 _dummy blockage layer.
for proper layer info, consult with ur CAD department
Click to expand...


ajaytronic is right. you may also refer to your layer assignment table about these dummy blockage layer.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top