Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

problem with programming pic 16f84a

Status
Not open for further replies.
M

MICROCHIP1

Newbie level 2
Joined
May 26, 2007
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
16f84a 13v

hi
i have a serious problem with programming pic 16f84a using ujdm programmer

i always have a verify error at location 0000h
can any one tell me what is going on please

Added after 8 minutes:

i forgot to say that i am using ic-prog 1.05e as a software (win xp )
sorry
 

Upload schematic for you programmer,
Possibility for many reason for this,
1. bad pic (try with another),
2. check communication cabel,
3. If you are setting CP ON bit, your programmer reed all location like empty,
4. JDM programmer use power from PC motherboard, may be your not capable to do this (do you before succesfuly programm some pic),
regards
 

I think the most likely cause is the /MCLR voltage which is too low. The part then fails to enter programming mode.
Measure the /MCLR voltage and if it is not 13V, then that is the problem.
Otherwise try using another PIC, see if it programs.
 

VVV said:
I think the most likely cause is the /MCLR voltage which is too low. The part then fails to enter programming mode.
Measure the /MCLR voltage and if it is not 13V, then that is the problem.
Otherwise try using another PIC, see if it programs.
Click to expand...

Hi, i think too that problem is low voltage.
it's a typical problem of programmer without external power supply as jdm...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top