Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Anyone has simulated LM741 ?

Status
Not open for further replies.

holddreams

Full Member level 6
Joined
Aug 2, 2005
Messages
351
Helped
15
Reputation
30
Reaction score
7
Trophy points
1,298
Location
Shanghai
Activity points
4,237
lm741 pspice

Is there anyone who has simulated LM741 circuit before?
How can I get the spice model?
Thanks.
 

pspice lm741

I'm pretty sure lots of people will have simulated an LM741 before! You'll find a Spice model here:

**broken link removed**
(**broken link removed**)

David

PS I haven't tried the model myself.
 

    holddreams

    Points: 2
    Helpful Answer Positive Rating
lm741 spice

Dear,

if you are using ORCAD or Protel or any other software,they usually

have the LM741 spice model!! any simulation software contains this model.


Good Luck!
 

    holddreams

    Points: 2
    Helpful Answer Positive Rating
lm741 spice model

Thanks for your replies.

Would you please tell me the difference between bipolar circuits simulation and cmos circuits simulation?
 

lm741 in pspice

holddreams said:
Would you please tell me the difference between bipolar circuits simulation and cmos circuits simulation?

Hi,

usually nothing,but you should be careful because when you use Transient Simulation
in OrCad or other simulation softwares and you use mixed circuits like opamps, you

may see convergence Error.Because the solvers of these software usually solve
equation at minimum time step,this means your time step is too small because

usually you have a little R*C in your circuit.this may be caused by OPAMP or any
other mix model.in this case you should use resistors with your sources or

at opamp inputs.

Good Luck!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top