Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Op-amp as voltage-divider?...

Status
Not open for further replies.

gelidude

Junior Member level 2
Joined
Apr 14, 2007
Messages
21
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,281
Location
Philippines
Activity points
1,475
op amp voltage divider

Just wondering, can an op-amp be used as a buffered voltage-divider instead of introducing gain in a circuit.
 

op amp divider

give the output of the voltage divider to a voltage follower... thus the voltage dividers output gets buffered as well as is independent of the load since the input current of op amp is zero...
 

op amp divider circuit

An op amp used in an inverting amplifier configuration can have any gain including less than one. Thus is can be used as a buffered voltage divider.
 

opamp divider

But the gain will be negative. So be careful if your circuit doesn't have reverse protect. I will use the op amp as an adder of two or more other op amps with both inverting and non-inverting gains.
 

voltage divider op amp

if u require help then contact me

Added after 21 seconds:

do contact
 
op-amp as divider

why would you want to do a divider with an op-amp, when it can be done much more cheaply with resistors?

-M
 

op-amp voltage divider

Because any resistive load on that simple resistor divider will mess up your division accuracy, not to mention it might be fairly high impedance node which might be susceptible to noise. You want to use the op-amp as a buffer so you can drive your reference over wider varying loads.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top