Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

12V automotive battery capacity tester (STM8).

Status
Not open for further replies.
D

DeepOne

Advanced Member level 2
Advanced Member level 2
Joined
Feb 26, 2011
Messages
632
Helped
99
Reputation
200
Reaction score
100
Trophy points
28
Location
45N39E, Russia
Activity points
0
this tester will show battery capacity after discharge to preferred minimum voltage value and than disconnect load. end of discharge is marked by sound from buzzer.
 

Attachments

  • c_hex_pcb_schm.zip
    55.8 KB · Views: 156

buttonless version. simple discharge battery to 10,5V.
 

Attachments

  • a_tst_kl.rar
    44.8 KB · Views: 147

Very nice!

I've seen several of your designs, and I'm very impressed with your capability to etch PWBs which will accommodate SMT components.
 

thanks, but i can not see nothing especial in such design.
 

Perhaps I should explain a little better what I meant:

It is very easy to make sophisticated and complex designs when one has a lot of money and resources.

It is very difficult when you do the same with limited resources like you do. To do so, it takes a lot of ingenuity and work, and I'm congratulating you on your ingenuity and your work. :thumbsup:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top