ShuKosugi
Junior Member level 1
Hello Guys...here I am again...am still getting unclear idea on how to load test my power supply PCF250-4001. Really needed help who can explain in "layman's terms". You can see the image below the power supply drawing...so how I am going to connect the load (using load resistor) to satisfy the condition written in user manual of this power supply...thanks.
Conditions:
Total current available from V1 + V2 is 40 amperes, total current available from V3 + V4 is 6.6 amperes.
Minimum Load, V1 Min. load required to maintain regulation on V2 is 4 Amps
Minimum Load, V3 Min. load required to maintain regulation on V4 is 0.6 Amp
Conditions:
Total current available from V1 + V2 is 40 amperes, total current available from V3 + V4 is 6.6 amperes.
Minimum Load, V1 Min. load required to maintain regulation on V2 is 4 Amps
Minimum Load, V3 Min. load required to maintain regulation on V4 is 0.6 Amp